Custom Sunelco EnerMatic Ugrades

This firmware is only applicable to the Sunelco project. Installing this in a stanard Enermatic will result in very confusing operation. DO NOT INSTALL ANYTHING ON THIS PAGE UNLESS YOU ARE SUNELCO.

SUNELCO EnerMatic Upgrade Firmware: 1.0.22

Version Date Notes

1.0.22 November 16, 2005 Changes made in regulator code to improve timing.

1.0.16 June 29, 2005 See notes for standard EnerMatic

1.0.15 June 28, 2005 Fixed bug in engine logic, and added Amps test to stop logic.

1.0.14 June 24, 2005 Fixed memory bug in rap server.

1.0.13 June 23, 2005 Fixed out of memory bug.

1.0.12 June 22, 2005 Fixed problem with firmware updater failing. Units with older firmware may require sending the unit to the factor for an update. Call PowerTap if you can not perform an update.

1.0.10 June 16, 2005 Fixed a bug in the rap server to accept \n and \r\n properly. Made some improvements to harden the rap server from too much input, and added an error code, E10, indicating that the input line is too long.

1.0.7 Fixed a bug which made charger maximum Amps 1/2 of programmed value.

Version	Date	Notes
1.0.22	November 16, 2005	Changes made in regulator code to improve timing.
1.0.16	June 29, 2005	See notes for standard EnerMatic
1.0.15	June 28, 2005	Fixed bug in engine logic, and added Amps test to stop logic.
1.0.14	June 24, 2005	Fixed memory bug in rap server.
1.0.13	June 23, 2005	Fixed out of memory bug.
1.0.12	June 22, 2005	Fixed problem with firmware updater failing. Units with older firmware may require sending the unit to the factor for an update. Call PowerTap if you can not perform an update.
1.0.10	June 16, 2005	Fixed a bug in the rap server to accept \n and \r\n properly. Made some improvements to harden the rap server from too much input, and added an error code, E10, indicating that the input line is too long.
1.0.7		Fixed a bug which made charger maximum Amps 1/2 of programmed value.